The first thing you want to do is measure your towel. I”m not sure what the standard measure for a bathroom hand towel is but mine was 19 inches wide.
Now do the math. I made my strips 3 X 6 1/2 inches wide (give or take a few). Not all of my scraps made the measurements which was fine. I’m a flexible kinda girl. Just add another strip or make some of the other strips wider.
Now sew your strips together in rainbow order. As you can see, because of my flexible attitude, one towel ended up with more pieces. This is easy to remedy as you press your “hems”.
Now press those seams. 1st, press all of the sewn seams in the same direction. Make sure to turn over and press in the crease so you get the maximum fabric allotment. 2nd, press a 1/2 inch “hem” around the rectangle. Remember to check the short ends against the towel because depending on the width of the towel, and your scrappy pieces, you may need to press the “hem” on the short sides a bit more than a 1/2 inch.
Now lay your rectangle out on the towel and pin in place. I wanted to cover the original “embellishment” so mine was pinned about an inch from the bottom.
Check that your short side hem is even with the edge of the towel and pin.
And there you have it. Pretty, embellished towels just perfect to brighten up your bathroom.
Or someone else’s. This set is off to a house full of pretty, rainbow lovin’, Spoonflower square set selling, ladies.